PDA

View Full Version : Play in transfer case?



Muggus
03-09-2007, 08:03 PM
I recently had a problem where my bell housing striped so my t-case started to walk off a bit. I felt the vibration while driving. I took it off and replaced all the stripped ones with longer bolts and nuts. However the input for the t-case has a little left and right play. Wasnt sure if that was normal or was damaged by moving around. I figured maybe the output from the trans would keep it from moving but still wanted to check. Also the trans output has a little in and out play but it didnt really feel too bad. Does any of that feel abnormal? Thanks

CHRIS
03-09-2007, 09:32 PM
i've always noticed a bit of play when you grab the drive shaft. rotates maybe 30 degrees.
and thats across atleast 15 1g's i've been under

Muggus
03-10-2007, 12:19 AM
The part that has some play on mines isnt on the driveshaft side. Its the female part of the t-case and the male of the trans that goes into it.

Muggus
03-11-2007, 04:09 AM
I took the transfer case off a different car today it was solid so i think mine might be screwed. Probably fucked a bearing or something, never took a t-case apart.