PDA

View Full Version : Car wont start..please help..


Adriano
10-03-2005, 10:13 PM
I did a headgasket swap on my car and now it wont start. I thought it was the cas, but today I put in another one and it still doesn't work. The car has no spark. Checked everything and it looks normal. Anyone with any idea of what it could be?? Thanks

Adriano
Monger
10-04-2005, 01:35 AM
if its the 95 in your sig, did you do the 1g cas swap before you did the headgasket? in other words, did it ever run on a 1g cas?
talondsm18g
10-04-2005, 03:22 AM
Something with ur EMS maybe?
Adriano
10-04-2005, 08:33 AM
Sorry, it's a 95 and I did the 1G cas swap while doing the headgasket. I broke the cam angle sensor when taking it out, that's why I put the 1G in. Today I will put the stock ecu back on and see it changes anything. Thanks.

Adriano
Adriano
10-05-2005, 12:04 AM
Today I put in the stock ecu and mas and still no luck. If anyone can come out to my house and give me a hand, I willing to pay. I getting frustated and running out of ideas. Thanks

Adriano
martin@rx4speed
10-05-2005, 12:16 AM
did you wire it according to road race/magnus instructions?
talondsm18g
10-05-2005, 12:38 AM
its possible you have a bad cas
Adriano
10-05-2005, 08:35 AM
I wired it according to road race/mganus motorsports intructions. I already bought 2 1G cas. TIA

Adriano
Monger
10-05-2005, 01:13 PM
man, dont make me come out there. I'm actually free today from now till about 5pm, so if you want me to come by give me a buzz 973 476 6767. if you're in North Arlington, it'll take me a half hour to get there. I charge 40 an hour, it usually takes me a half hour to wire up a 1G cas, but I'm gonna have to charge you for travel time :lol:
Adriano
10-07-2005, 08:15 PM
Ok, tomorow I will be back at the garage and see if I can figure out what's wrong with the car (didnt touch it this week due to work). Is the rpm supposed to move when you try to start the car? Mine doesn't move at all. What kind of signal/volts should i see at the cas wires that sends signal to the ecu? Thanks

Adriano
Adriano
10-08-2005, 03:02 PM
It finally started. I went to the junk yard and picked up a new cas plugs and made a new wiring harness. The car fired right up. Now I got a new problem, it's leaking alot of oil thru the oil pump/filter housing area?? I'm gonna remove the belts and cover and see where it is. Thanks

Adriano
h2osk8er97
10-12-2005, 12:42 AM
Have you fixed the leak yet? I had a massive oil leak and it turned out being the nut thats on far the end of the stud that the oil filter screws on. Im pretty sure it hold the oil filter housing to the oil cooler. Try to give that a few turns and see what happens. Hope this helps